02.19.2009 11:04 AM
Nucomm to roll out ProQ IFB receiver

Nucomm will debut its ProQ DTV IFB receiver designed for use as an IFB solution for ENG users during DTV transmission, for monitoring DTV signals through a DVB-ASI output and streaming video over an IP connection to a laptop or other IP-enabled device.

The new ProQ DTV IFB receiver is 5in by 1.75in by 8.5in and features dual UHF/VHF antennas, two silicon tuners and sixth generation VSB demodulators.

The ProQ contains an MPEG Layer 1/Layer 2 audio decoder that is capable of decoding two independent sound programs, providing up to four audio channels and using bit rates as low as 32kb/s for each. Coupled with low-latency audio encoders and proper design of the DTV packet insertion, total audio latency can be less than 80ms. Its audio signal outputs are outfitted on a 5-pin XLR connector.


Comments
Post New Comment
If you are already a member, or would like to receive email alerts as new comments are
made, please login or register.

Enter the code shown above:

(Note: If you cannot read the numbers in the above
image, reload the page to generate a new one.)

No Comments Found




Thursday 10:05 AM
NAB Requests Expedited Review of Spectrum Auction Lawsuit
“Broadcasters assigned to new channels following the auction could be forced to accept reductions in their coverage area and population served, with no practical remedy.” ~NAB


 
Featured Articles
News Technology
News Technology
Discover TV Technology