08.26.2005 03:31 PM
Phihong offers single port injector for Gigabit systems


The new power injector is designed for Power-over-Ethernet applications using Gigabit systems.

Phihong has developed a single port power injector for Power-over-Ethernet (PoE) applications for use with Gigabit systems. The PSA20U is compatible with systems up to 1000Mb/s.

PoE technology is designed to address problems involving AC power and the placement of power outlets. PoE allows both power and data to be carried over an Ethernet cable.

The output of the 20U provides 19.6W power while complying with IEEE 802.3af detection and fault protection requirements.

Development of the GB single-port injector was driven by the high data rate requirements of broadband wireless 802.11n access points and high-quality IP cameras with streaming video, as well as remote-mounted devices. These applications also require high power capabilities.

AC input voltage range for the single port injector is 90VAC to 264VAC with input frequency from 47Hz to 63Hz. Maximum output load current is 350mA and O/P voltage is 56VDC. The device offers total output power of 19.6 with fully compliant detection, connection, disconnection and fault protection per the IEEE 802.3af standard.

For more information, visit www.phihong.com/html/poe.html.

Back to the top




Comments
Post New Comment
If you are already a member, or would like to receive email alerts as new comments are
made, please login or register.

Enter the code shown above:

(Note: If you cannot read the numbers in the above
image, reload the page to generate a new one.)

No Comments Found




Thursday 10:05 AM
NAB Requests Expedited Review of Spectrum Auction Lawsuit
“Broadcasters assigned to new channels following the auction could be forced to accept reductions in their coverage area and population served, with no practical remedy.” ~NAB


 
Featured Articles
News Technology
News Technology
Discover TV Technology