10.03.2013 09:06 AM
Integrated Microwave Technologies showcases Nucomm range booster at IBC2013
The Nucomm RBA is designed to increase the transmission range of camera-back and portable transmitters.

Integrated Microwave Technologies featured its Nucomm Range Booster Amplifier (RBA) last month at IBC2013.

The Nucomm RBA is designed to increase the transmission range of camera back and portable transmitters. It fits directly on the RF output of the Nucomm CamPac, RF Central microLite or Compact Portable Transmitter (CPTx), and boosts the power from 200mW to 1W.

The small, lightweight amplifier is powered by the camera battery via a D-Tap or P-Tap to a six-pin Lemo connector. It features RF 

auto detecting and transmitting, when an RF input is applied. When an RF input is not detected, the RBA automatically goes to standby, drawing less than 1W.

The Nucomm RBA also features an internal leveling loop, giving the unit a wide RF power input range while holding a constant output of 1W. The leveling loop coupled with the built-in digital pre-distortion feature keeps the adjacent channel spectral regrowth essentially the same as the transmitter being used.

Post New Comment
If you are already a member, or would like to receive email alerts as new comments are
made, please login or register.

Enter the code shown above:

(Note: If you cannot read the numbers in the above
image, reload the page to generate a new one.)

No Comments Found

Wednesday 11:59 PM
Peer Profile: Tomaž Lovsin, STN, Slovenia
“Will there be a shift from coax to fibre? Or a mixture between the two which will require hybrid solutions to be implemented?”

Wall Street Communications /   Wednesday 07:02 PM
SMPTE Announces 2014 Honorees and Award Winners
HighRez /   Tuesday 02:21 PM
Over The Air and Cable TV: Far From Dead

Featured Articles
Discover TV Technology