06.09.2008 08:00 AM
MultiDyne introduces multimode fiber transport

MultiDyne introduced the DVI-5000 Multimode Fiber Optic Link, a transport solution for short runs of high-quality uncompressed DVI signals over one or two fibers.

The DVI-5000 features stereo audio and data, and support for DVI video signals up to WQXGA resolution of 2560 x 1600 over one or two fibers. The DVI Single Link version requires only one fiber for resolutions up to WUXGA 1920 x 1200, while the DVI Dual Link version requires two fibers for resolutions up to WQXGA 2560 x 1600. The system also supports stereo audio and bidirectional data for monitor control and uses no compression, with no user adjustments or calibration.

The system transports a pixel-for-pixel image that is 100 percent transparent without frame dropping, and enables 24-bits for all scan rates without contouring or bit reduction at a high scan rate. It also provides a total throughput of up to 10Gb/s and requires nonproprietary multimode fiber-optic cable with a transport distance of up to 1km or 3300ft.

The DVI-5000 transmitter unit supports a loop-through input and the receiver provides two DVI outputs. It supports EDID from any monitor that is selectable between the loop-through monitor, internal generation on the transmit side or from the monitor on the receiver side.

For more information, visit www.multidyne.com.



Comments
Post New Comment
If you are already a member, or would like to receive email alerts as new comments are
made, please login or register.

Enter the code shown above:

(Note: If you cannot read the numbers in the above
image, reload the page to generate a new one.)

No Comments Found




Thursday 10:05 AM
NAB Requests Expedited Review of Spectrum Auction Lawsuit
“Broadcasters assigned to new channels following the auction could be forced to accept reductions in their coverage area and population served, with no practical remedy.” ~NAB


 
Featured Articles
Conference Updates
Technology in Focus
Discover TV Technology