08.16.2010 01:45 PM
IBC: Gefen Premiering Cross-Point Matrix Switchers

At IBC Gefen will premier the new GefenPRO product line with a range of cross-point matrix switchers for broadcast, rental/staging and post-production. All include internal power supplies, front-panel routing and 24/7 technical support. Built-in EDID programming enhances stability of pre-settings after switching. RS-232 serial control, IR remote, front panel buttons and IP control using any webpage interface can be used to access and control. The GefenPRO 16x16 3G-SDI Matrix (pictured) routes any 16 sources to any 16 destinations with full cross-point capability. Resolutions are supported up to 1080p or 1920x1200. This matrix offers redundant power supplies so that if one should fail, the other will automatically power on, eliminating signal loss due to power cord failure.

Gefen will be at stand 7.B30.



Comments
Post New Comment
If you are already a member, or would like to receive email alerts as new comments are
made, please login or register.

Enter the code shown above:

(Note: If you cannot read the numbers in the above
image, reload the page to generate a new one.)

No Comments Found




Thursday 10:05 AM
NAB Requests Expedited Review of Spectrum Auction Lawsuit
“Broadcasters assigned to new channels following the auction could be forced to accept reductions in their coverage area and population served, with no practical remedy.” ~NAB


 
Featured Articles
Research & Standards
Discover TV Technology